How to Smoke a Brisket on the Ninja Woodfire Grill
A full brisket timeline for the Ninja Woodfire: picking a cut that fits, trimming, smoking at 250°F, beating the stall, when to wrap, and the rest.
By the Dalqi kitchen · Updated 2026-11-16 · 4 min read

Short answer
Smoke a 4–6 lb brisket flat on the Ninja Woodfire at 250°F with one scoop of pellets. Expect 5–6 hours to reach about 165°F, when the stall usually hits. Wrap it in butcher paper or foil, then cook another 3–4 hours to about 203°F, or until a probe slides in like butter. Rest it wrapped for 1–2 hours before slicing against the grain.
Plan on 9–12 hours from grill to slicing, so start earlier than you think. Our step-by-step smoked brisket flat recipe has the exact rub and quantities.
Pick a brisket that fits
The Woodfire grill's cooking area is much smaller than a backyard offset smoker. A whole packer brisket (12–16 lb, with both the point and the flat) usually won't fit with the lid closed. Your options:
- A brisket flat, 4–6 lb. The easiest choice. It's leaner, slices neatly and fits the grate.
- A point, 3–5 lb. Fattier and more forgiving. Perfect for burnt ends.
- A packer cut in half between the point and the flat, cooked one at a time or one now and one frozen for later.
Measure your grate before you shop. The meat needs space around it for air and shouldn't touch the lid. Choose a flat with even thickness from end to end. A thin tail dries out long before the thick end is ready.
Trim and season
Trim off hard, waxy fat and silver skin, and leave about ¼ inch of soft fat on top. Round off thin edges and corners, which would otherwise burn. Smear on a thin binder like yellow mustard (you won't taste it) and coat the meat with a simple rub: coarse black pepper, kosher salt and a little garlic powder.
If you can, season the night before and leave it uncovered on a rack in the fridge. The salt works its way in, and the dry surface helps build bark.
The timeline, hour by hour
This schedule is for a 5 lb flat at 250°F with a target serving time of 7 p.m. Every brisket is different, so treat the times as a plan, not a promise.
| Time | Step | What to look for |
|---|---|---|
| Night before | Trim and dry brine | Even rub, uncovered in the fridge |
| 7:00 a.m. | Load pellets, preheat Smoker at 250°F | Thin, clean smoke |
| 7:15 a.m. | Brisket on, fat side up, probe in | Lid closed |
| 12:00–1:00 p.m. | The stall | Internal temp hovers around 150–170°F, bark dark and set |
| About 1:00 p.m. | Wrap | Bark doesn't smudge when touched |
| 4:00–5:00 p.m. | Done | About 203°F and probe-tender in several spots |
| 5:00–7:00 p.m. | Rest | Wrapped in a towel inside a dry cooler |
| 7:00 p.m. | Slice and serve | ¼-inch slices against the grain |
A brisket that finishes early is no problem. It can rest in a cooler for 3–4 hours and still be hot. A brisket that finishes late is the real problem, which is why the schedule has slack built in.
The stall: what it is and what to do
Somewhere around 150–170°F, the internal temperature stops rising and can sit there for an hour or several. Nothing is wrong. Moisture is evaporating from the meat's surface and cooling it, the same way sweat cools you. Once enough surface moisture is gone, the temperature starts climbing again.
You have two choices. You can wait it out, which gives the firmest bark but adds hours. Or you can wrap the brisket, which traps moisture, stops the evaporative cooling and pushes the meat through much faster. On an electric grill where you're working with a set schedule, wrapping is usually the better option. Don't turn the temperature way up to beat the stall; that dries out the flat.
Wrapping: butcher paper or foil
Wrap once the bark is dark and set, meaning a finger touch doesn't smear the rub. That's usually around 160–170°F.
- Butcher paper (unwaxed, pink or white) breathes a little. It keeps more of the bark's texture and still speeds up the cook.
- Foil seals completely. It's the fastest way through the stall and keeps the meat very moist, but the bark softens.
Lay down two overlapping sheets, set the brisket in the middle, add a splash of beef broth, and fold it tightly, seam side down. Put it back on the grill with the probe reinserted through the wrap.
When is it done?
Brisket is done when it's tender, not when it hits a specific number. Most flats get there between 200°F and 205°F. Push a probe or skewer into several spots; it should slide in with almost no resistance, like going into soft butter. If any spot feels tight, give it another 30 minutes and check again.
For safety, brisket is far past the USDA minimum of 145°F long before it's tender. The high final temperature is about breaking down connective tissue, not food safety.
Resting and slicing
Resting is part of the cook, not optional. Keep the brisket wrapped, wrap it in an old towel, and set it in an empty, dry cooler for at least 1 hour and up to 3–4. The juices settle back into the meat, and it stays hot. Slicing right off the grill sends those juices onto the board.
Slice ¼ inch thick against the grain. Find the direction the muscle fibers run before you start, and cut across them. Keep the leftovers in a little of the collected juices so they reheat well. Brisket goes well with smoked mac and cheese made on the same grill once the meat comes off to rest.
Common brisket mistakes on the Woodfire
- Starting too late. Build in at least 2 hours of buffer.
- Opening the lid to check. Use a leave-in probe; every peek drops the temperature and lets smoke escape.
- Too many pellets. One scoop. More smoke isn't better smoke.
- Pulling at a number, not by feel. 203°F is a guide. Tenderness decides.
- Skipping the rest. An hour in a cooler makes a big difference.
- Slicing with the grain. Even a perfect brisket is chewy cut the wrong way.
Once you've nailed brisket, try baby back ribs or pulled pork, which follow the same low-and-slow rules with less waiting.
FAQ
How long does it take to smoke a brisket on a Ninja Woodfire?
For a 4–6 lb flat at 250°F, plan on 8–10 hours of cooking plus 1–2 hours of resting. Start early and let it rest in a cooler if it finishes ahead of schedule.
Can a whole packer brisket fit in a Ninja Woodfire grill?
Usually not. Most whole packers are too big for the grate with the lid closed. Use a flat or point, or cut a packer in half and cook the pieces separately.
What temperature should brisket reach?
Most brisket is tender between 200°F and 205°F. Go by feel: a probe should slide in with almost no resistance in several spots.
Should I wrap brisket in foil or butcher paper?
Butcher paper keeps a firmer bark; foil is faster and moister but softens the bark. Both get you through the stall.
How long should brisket rest?
At least 1 hour, wrapped and kept in a dry cooler. It can rest 3–4 hours and still be hot enough to serve.
Recipes to try
WoodfireSmoked Brisket Flat on the Ninja Woodfire Grill
582 kcal · 40 g protein · 565 min
WoodfireBrisket Burnt Ends from the Point (Ninja Woodfire Grill)
503 kcal · 30 g protein · 500 min
WoodfireSmoked Pulled Pork on the Ninja Woodfire Grill
547 kcal · 39 g protein · 680 min
WoodfireSmoked Baby Back Ribs on the Ninja Woodfire Grill
932 kcal · 46 g protein · 290 min
WoodfireSmoked Mac and Cheese (Ninja Woodfire Grill)
417 kcal · 17 g protein · 80 min

